INSTRUCTIONS
- PROFESSOR MOTOR WIRING CENTER (PMTR1045)
Wiring
directions for positive polarity controllers
:
#9 Wire to +
power : main power feed from (red) power supply
#1
#7 Wire to +
power : main power feed from (red) power supply
#2
#3 Wire to -
power : main power feed from (black) BOTH
power supplies
#6
Wire to the white post (power) for lane #1
#8
Wire to the white post (power) for lane #2
#1
Wire to the red post (brake) for lane #1
#5
Wire to the red post (brake) for lane #2
#2
Wire to left side braid/rail of track lane #1
#4
Wire to left side braid/rail of track lane #2
Other
wiring (not connected to wiring center)
:
Wire
black (track) controller post for lane #1 to right side braid/rail of lane #1
Wire
black (track) controller post for lane #2 to right side braid/rail of lane #2
This wiring center is designed
for DUAL power supply input (one power supply per
lane). It will provide
protection against short circuit and overload conditions that may be encountered
due to misconnected controllers, track wiring issues or any slot car related
issue that might cause excessive current draw.
In doing so the controllers, track, cars and track wiring are all
protected against potential electrical issues and resulting damage.
The self-resetting circuit breakers used will restore power automatically
without any need for a manual reset or fuse replacement after the electrical
issue is resolved.
|