Thank you for purchasing the Ninco Dual Power Base Home
Set Controller (PMTR2045)
Intended
application : 1/32 home
track racing
This model features the following high quality features
·
Recommended Operating
Voltage Range : 14 to 19 volts
·
New “Silver Series” ultra robust design features (see web site
for information)
·
Extra long, heavy duty 16 gage PVC insulated controller leads with
¼” plug
·
High impact polycarbonate plastic molded handle
·
Full electronic semiconductor design with ultra wide range of
control
·
Resistor modulated braking system for improved on-track
performance
·
Low friction graphite impregnated wiper button
·
Brass alloy wiper contacts
·
PMTR2031 Low Friction Trigger Bushing
·
Stainless steel hardware throughout
·
Upgradeable modular design
Use
& Care Instructions
·
Because of extreme weakness in the Ninco power base system only
connect or disconnect these controllers with the power disconnected from the
terminal track.
·
This controller is wired for negative polarity track wiring
configurations. With the Ninco dual
power base either direction of movement is possible without installation of the
polarity switch.
·
With an adapter to reduce the plug to 3.5mm this controller can be
used on the Ninco “single power base” or the Scalextric Sport track system
·
Caution ! : Wires on the circuit board may be very sharp
and can cause injury if handled with the external housing removed
Optional
upgrades for this controller
·
PMTR2030 Power & Polarity Pilot Light System
·
PMTR2071 Low Cost variable sensitivity system (use if racing with
14 volt transformers)
·
PMTR2070 Variable sensitivity system with external knobs
Regular
maintenance
·
Clean wiper button with 400 - 500 grit emery paper (slide paper
under wiper)
·
Clean brass contacts using 600 - 800 grit emery paper (carefully
remove all brass dust)
·
Oil the trigger pivot bushing (top & bottom) with a light
machine oil
“Ninco”
is a registered Trademark of Ninco Desarrollos Sl, Spain.
controller
tech tips & information