Thank you for purchasing the "Silver Series" HO
& 1/32 "Low Cost" Model (PMTR2047)
Intended application : HO & 1/32 club & commercial track racing where
higher voltage power supplies (15 to 20 volts) are used - POSITIVE polarity
This model features the following high quality features
·
New “Silver Series” ultra robust design features (see web site
for information)
·
Self resetting electronic circuit breaker system in brake circuit
·
Extra long 16 gage PVC insulated controller leads
·
Nickel plated steel alligator clips
·
Low friction trigger bushing
·
Color coded vinyl insulating boots
·
High impact polycarbonate plastic molded handle
·
Full electronic semiconductor design with ultra wide range of
control
·
Low friction graphite impregnated wiper button
·
Brass alloy wiper contacts
·
Stainless steel hardware throughout
·
Upgradeable
modular design
Use & Care Instructions
· This controller is wired for positive polarity track configurations.
Addition of the optional polarity switch system is required for proper operation
on negative track wiring
· Caution ! : If connected incorrectly to power, permanent damage can result.
· Caution ! : Wires on the circuit board may be very sharp and can cause injury
if handled with the external housing removed
Optional upgrades for this controller
· Glue-on heat sink direct mounted to semiconductors (if high performance
motors are used)
· PMTR2038 Variable Brake System
· PMTR2036 Reversing Switch System - Allows use on negative wired tracks
· PMTR2037 Power Relay System
· PMTR2071 Low Cost Variable Sensitivity System
· PMTR2070 Variable Sensitivity System
· PMTR2030 Power & Polarity Pilot Light System
Regular maintenance
· Clean wiper button with 400-500 grit emery paper (slide paper under wiper)
· Clean brass contacts using 600 grit emery paper (carefully remove all brass
dust)
· Oil the trigger pivot bushing (top & bottom) with a light machine oil
controller
tech tips & information