Thank you for purchasing the Silver Series HO & 1/32
"Rental" Model (PMTR2049)
Intended application : Rental controller for HO & 1/32 club & commercial
track racing where higher voltage power supplies (15 to 20 volts) are used -
POSITIVE Polarity
This model features the following high quality features
· New "Silver Series" ultra robust design features (see web site for
information)
· Full short circuit & overload protection via self resetting electronic
circuit breakers
· Glue-on heat sink direct mounted to semiconductors
· Extra long 16 gage PVC insulated controller leads
· Solid copper alligator clips
· Low friction trigger bushing
· Color coded vinyl insulating boots
· High impact polycarbonate plastic molded handle
· Full electronic semiconductor design with ultra wide range of control
· Low friction graphite impregnated wiper button
· Brass alloy wiper contacts
· Stainless steel hardware throughout
· Upgradeable modular design
Use & Care Instructions
· This controller is wired for positive polarity track configurations.
Addition of the optional polarity switch system is required for proper operation
on negative track wiring
· Caution ! : If connected incorrectly to power, permanent damage can result.
· Caution ! : Wires on the circuit board may be very sharp and can cause injury
if handled with the external housing removed
Optional upgrades for this controller
· PMTR2036 Reversing Switch System - Allows use on negative wired tracks
· PMTR2071 Low Cost Variable Sensitivity System
· PMTR2070 Variable Sensitivity System
· PMTR2030 Power & Polarity Pilot Light System
Regular maintenance
· Clean wiper button with 400-500 grit emery paper (slide paper under wiper)
· Clean brass contacts using 600 grit emery paper (carefully remove all brass
dust)
· Oil the trigger pivot bushing (top & bottom) with a light machine oil
controller
tech tips & information