Thank you for purchasing the 1/32 & HO "Silver
Series" Base Model Controller (PMTR2055)
Intended application : 1/32 & HO Home & Commercial Track Racing
This model features the following high quality features
·
Recommended
operating voltage range 12 to 15 volts DC
·
New “Silver Series” ultra robust design features (see web site for detail)
·
Self resetting electronic circuit breaker system
·
Extra long, heavy duty 16 gage PVC insulated controller leads
·
Low friction trigger bushing
·
Nickel plated alligator clips
·
Color coded vinyl insulating boots
·
High impact polycarbonate plastic molded handle
·
Full electronic semiconductor design with wide range of control
·
Low friction graphite impregnated wiper button
·
Brass alloy wiper contacts
·
Stainless steel hardware throughout
·
Upgradeable modular design
Use & Care Instructions
· This controller is wired for positive polarity track configurations.
Addition of the optional polarity switch system is required for proper operation
on negative track wiring
· Caution ! : If connected incorrectly to power, permanent damage can result.
· Caution ! : Wires on the internal circuit board may be very sharp and can
cause injury if handled with the external housing removed
· Addition of the optional heat sink is highly recommended for use with higher
powered cars
Optional upgrades for this controller
· PMTR2038 Variable Brake System
· PMTR2036 Polarity Reversing Switch System - Allows use on negative wired
tracks
· PMTR2037 Power Relay System
· PMTR2070 Variable Sensitivity System
· PMTR2071 Low Cost Variable Sensitivity System
· PMTR2069 Heat Sink (for use with PMTR2070 Variable Sensitivity System)
· PMTR2033 Heat Sink (for use when PMTR2070 is NOT used)
· PMTR2030 Power & Polarity Pilot Light System
· PMTR2011 / 2013 / 2014 / 2015 / 2016 Silicone 13 Gage Wire Harness
Regular maintenance
· Clean carbon wiper button with 400-500 grit emery paper (slide paper under
wiper)
· Clean brass contacts using 600 grit emery paper (remove all brass dust with
lighter fluid)
· Oil the trigger pivot bushing (top & bottom) with light machine oil
controller
tech tips & information