Thank you for
purchasing the Professor Motor HO & 1/32 Club Racer "Gold" Model -
PMTR2056
Intended
application : HO & 1/32 home & commercial track racing
This model
features the following high quality features
·
Recommended operating voltage range 12
to 19 volts DC using variable sensitivity
·
Polarity switching system to allow operation on any home, club or
commercial track wiring
·
Full electronic semiconductor design with ultra wide range of
control (50% more range)
·
Variable Sensitivity system with external adjusting knobs &
over 40,000 possible settings
·
New design low friction brass/steel trigger bushing system
·
“Silver Series” ultra robust design features (see web site for
information)
·
Self resetting electronic circuit breaker to help prevent damage
from accidental short circuit
·
Extra long, heavy duty 13 gage super flexible, high temp silicone
controller leads
·
Solid copper alligator clips with color coded vinyl insulating
boots
·
High impact polycarbonate plastic molded handle
·
Low friction graphite impregnated wiper button with brass alloy
wiper contacts
·
Stainless steel hardware throughout
·
Upgradeable
modular design
Use & Care
Instructions
· To activate the variable sensitivity system turn the silver knobs until
bottoming, but be careful
not to overtighten (snug only). Suggested use - make sure all the knobs are
backed away from
the "bottomed" position, start by turning in the front one (nose of
controller) until bottomed &
continue left to right until suitable sensitivity is achieved.
· To deactivate the variable sensitivity "switches" back off the
knobs from the bottomed position
only ½ to ¾ turn (excessive loosening can cause the knobs to fall off).
· Caution ! : Be careful when placing the controller down on a commercial track
to avoid contact
with the wiring connections to the track. The silver knobs for the sensitivity
system are electrically
active and a short circuit could result.
· Caution ! : If connected incorrectly to power, permanent damage can
result.
· Caution ! : Wires on the circuit board may be very sharp and can cause injury
if handled
· Caution ! : Sensitivity knobs may get very hot if high-powered motors are
used. It is recommended
that shrink wrap tubing be used to cover the sensitivity knobs to prevent
injury.
Optional upgrades
for this controller
· Variable brake system (PMTR2038)
· Power relay system (PMTR2037)
· Power pilot lights (PMTR2030)
· Heat sink (PMTR2069)
Regular
maintenance
· Clean wiper button with 400-500 grit emery paper (slide paper under
wiper)
· Clean brass contacts using 600-800 grit emery paper (carefully remove all
brass dust)
· Oil the trigger pivot bushing (top & bottom) with a light machine oil
controller tech tips & information