Thank you for purchasing the "Silver Series"
Commercial Track Electronic Controller (PMTR2058)
Intended application : 1/24 & 1/32 commercial track racing
This model features the following high quality features
· New "Silver Series" ultra robust design features (see web site for
information)
· Self resetting electronic circuit breaker system in brake circuit
· Extra long, heavy duty 13 gage super flexible, high temp silicone controller
leads
· Solid copper alligator clips
· Color coded vinyl insulating boots
· High impact polycarbonate plastic molded handle
· Full electronic semiconductor design with wide range of control
· Low friction graphite impregnated wiper button
· Brass alloy wiper contacts
· Low Friction Trigger Bushing
· Stainless steel hardware throughout
· Upgradeable modular design
Use & Care Instructions
· This controller is wired for positive polarity track configurations.
Addition of the optional polarity switch system is required for proper operation
on negative track wiring
· Caution ! : If connected incorrectly to power, permanent damage can result.
· Caution ! : Wires on the circuit board may be very sharp and can cause injury
if handled with the external housing removed
· Addition of the optional heat sink is highly recommended for use with higher
powered cars
Optional upgrades for this controller
· PMTR2038 Variable Brake System
· PMTR2036 Reversing Switch System - Allows use on negative wired tracks
· PMTR2037 Power Relay System
· PMTR2071 Low Cost Variable Sensitivity System
· PMTR2033 Heat Sink (for use when PMTR2070 is NOT used)
· PMTR2030 Power & Polarity Pilot Light System
Regular maintenance
· Clean carbon wiper button with 400-500 grit emery paper (slide paper under
wiper)
· Clean brass contacts using 600-800 grit emery paper (carefully remove all
brass dust)
· Oil the trigger pivot bushing (top & bottom) with a light machine oil
controller
tech tips & information