Thank
you for purchasing the “Silver Series” Carrera* Home Set Model (PMTR2062)
Intended
application : 1/32 &
1/24 Carrera* home track racing
This
model features the following high quality features
·
Direct plug-in compatibility with the Carrera* track system and 18
volt rated transformer
·
“Silver Series” ultra robust features, extra long 16 gage
insulated controller leads with plugs
·
High impact polycarbonate plastic handle, electronic semiconductor
design with wide range
·
Electronic circuit breaker protected braking system, low friction
graphite impregnated wiper
·
Brass alloy wiper contacts, stainless steel hardware, upgradeable
modular design
Use
& Care Instructions
·
It is recommended that connections
to the track be made with the power off.
·
This controller is polarity sensitive & is wired for
“NEGATIVE” polarity track wiring. For
proper operation the transformers and controllers need to be hooked up as
shown below (partial view of terminal track shown).
Note : if the cars do not move until the
controller is at wide open throttle then reverse the power supply leads at the
terminal track.
Caution
!
: Internal wiring on the controller circuit board may be very sharp and can
cause injury if handled with the external housing removed
Optional
upgrades for this controller
·
PMTR2036 Reversing Switch, PMTR2030 Power & Polarity Pilot
Light System
·
PMTR2038 Variable Brake System, PMTR2031 Low Friction Trigger
Bushing
·
PMTR2070 Variable Sensitivity System, PMTR2070 Low Cost Variable
Sensitivity System
Regular
maintenance
·
Clean wiper button with 400-500 grit emery paper (slide paper
under wiper)
·
Clean brass contacts using 600 grit emery paper (carefully remove
all brass dust)
Oil
the trigger pivot bushing (top & bottom) with a light machine oil
controller tech tips & information