Thanks for purchasing the “Scale
Racer PRO” HO & 1/32 Electronic Controller PMTR2111 (replaces 2053)
Intended
application : HO & 1/32 home, club & commercial track racing through 16D and
JK Falcon. Not recommended
for
Group 12 / 15 or high-powered glue racing
This
model features the following high quality features
·
Recommended operating
voltage range 14 to 19 volts DC
·
Wired for POSITIVE polarity
tracks (not for direct connection to home set power base)
·
Variable Braking System (high quality 25 Ohm wire wound pot to vary brake performance)
·
Variable Sensitivity System (high quality single wire wound pot to adjust
sensitivity setting)
·
Electronic “Platinum Series” transistor design with ultra wide range of
control
·
Fault tolerant ultra robust circuit design to protect against overload or short
circuit damage
·
Internal handle-protected aluminum heat sink
·
Fully functional in 2 wire (non-brake) application (some HO & 1/32)
·
Power pilot light system for power and polarity indication
·
Extra long, heavy duty 13 gage super flexible, high temp silicone controller
leads
·
Solid copper alligator clips with color coded vinyl insulating boots
·
High impact polycarbonate plastic molded handle, Stainless steel hardware
throughout
·
Low friction silver alloy wiper button with ultra hard nickel plated contact
surface
Use
& Care Instructions
·
Brake Adjust – Adjust the red color-coded knob with the white line “up”
for MAXIMUM braking effect. Turn
that
knob counter-clockwise to reduce braking effect.
·
Sensitivity Adjust - Adjust the silver color-coded knob with the white line “up”
for MINIMUM sensitivity. Turn
that
knob counter-clockwise to increase the sensitivity (provide more power to the
car on initial application of
the
throttle).
·
Caution ! : Regular maintenance is
required to keep the controller contacts clean and
free from foreign
objects
& debris. Failure to properly clean, lube and maintain the contacts will
cause the controller to fail, will
allow
the car to be driven without the throttle being depressed and can result in the
wire wound pot used for
brake
control becoming short circuited & damaged. Please take this warning
seriously and follow this
process
to keep the contacts clean & properly lubricated :
1.
Remove the front half of the controller case by loosening the three bolts
2.
Clean all debris from the nickel-plated contacts with a Q-Tip and lighter fluid
3.
The sliding contacts MUST be CAREFULLY lubricated to reduce contact wear and
provide a
smoother
controller action. To lube, do so as follows :
a.
Place a SMALL amount
of Super Lube PTFE lube on the end of a Q-Tip & apply to the
nickel
contacts in the area where the silver alloy contact travels
b.
Cycle the trigger a few times
c.
Use a Q-Tip with lighter fluid to remove any excess lube outside of the area
where the
contacts
meet (remove 90% of the lube you just applied)
d.
Examine the contact area to insure that cotton fibers from the Q-Tip are
removed and
that
residual lube is minimal & barely visible
4.
Repeat this cleaning / lube process on a frequent basis (every 1-2 weeks) for
best results.
·
Periodic Maintenance – lube the trigger pivot bushing with plastic compatible
oil
Optional Upgrades
·
Power Relay System PMTR2037 – provides a more positive low resistance path at
Wide Open Throttle
For
technical information, questions or the latest catalog of available service
parts and
upgrades
please visit us on the World Wide Web : www.professormotor.com