Wiring instructions for 2 lane
race director systems (PMTR6880) :
#9 Wire to + power : main power feed from
(red) power supply / battery
#3 Wire to - power :
main power feed from (black) power supply / battery
#6 Wire to the white post (power) for lane #1
#8 Wire to the white post (power) for lane #2
#1 Wire to the red post (brake) for lane #1
#5 Wire to the red post
(brake) for lane #2
#2 Wire
to left side braid/rail of track lane #1
#4
Wire to left side braid/rail of track lane #2
#10
Wire to “BLACK” lead of wires from 15 foot lap counter cable
#11
Wire to “RED” lead of wires from 15 foot lap counter cable
#7 connection is NOT
USED
Other wiring (not connected to
race director)
:
Wire black (track) controller
post for lane #1 to right side braid/rail of lane #1
Wire black (track) controller
post for lane #2 to right side braid/rail of lane #2
This race director allows the
track power to be turned on and off using computer control so that races can be
run. This system also uses an
integrated “wiring center” that provides protection against short circuit
and overload conditions that may be encountered due to misconnected controllers,
track wiring issues or any car related issue that might cause excessive current
draw. The controllers, track, cars
and track wiring are all protected against potential electrical issues and
resulting damage. The
self-resetting circuit breakers used will restore power automatically without
any need for a manual reset or fuse replacement after the electrical issue is
resolved. Ring type wire terminals
are included in this kit (not shown in illustration).
We recommend that all wire terminal connections are soldered for the best
reliability using electrical type 60/40 rosin core solder (do not use acid
flux). 16 gage wire minimum is
recommended for all connections. The
race director must be installed close to the lap counter system or the two wires
from the 15 foot cable that connect to terminal #10 & #11 must be extended
with 16 gage wire to the distance needed to reach the race director (carefully
solder & insulate the connecting wires).
PROFESSOR
MOTOR
www.professormotor.com
38291
Schoolcraft – Suite 104
Livonia,
MI 48150-5042
Phone
/ Fax : (734) 462-4226