

regulated 30 amp power supply for HO, 1/32 or 1/24
racing
Part Number
DPS400GL
Features - New Specs ! (picture not yet updated) 4 to 18 volt DC adjustable output power to accommodate dialing down performance for the benefit of young novice racers or to optimize power for rental equipment in a commercial raceway setting, 115 volt AC standard wall circuit input (North America only), short circuit and overload protection for safety to prevent damage to track wiring or equipment in the event of an inadvertent electrical overload, linear regulation (kinder to slot racing motors) which allows multiple lanes of a slot racing track (up to 8) to be powered without the potential for power interference between lanes. Equally at home as a bench mounted utility supply to power a wide variety of useful tools such as tire trimmers, commutator lathes, slot racing dynos and may also be used to carefully break in motors by running at reduced voltage, charge full size automotive batteries or power any device you would use in a car cigarette lighter (such as a cell phone charger). Supply includes a redundant set of output jacks on the back panel (not shown). Includes dual power meters for both amps and volts to measure power output in real time.
30 amp surge power rating, 18 amps continuous
NEW ! - Hook up this supply to Carrera track with the PMTR1048 wire harness.
NEW ! - Hook up this supply to Ninco or Scalextric with the PMTR1064 wire harness.