Sloting Plus Speed 3 Motor 21,500RPM 340 g-cm Torque - magnetic force 13-16 (scale from 0 to 20) - same size and applications as Ninco NC-2, 3, 5, 6 and similar motors - exposed end shaft allows (careful) lubrication of front bushing and more security while installing pinions - 2mm standard shaft - compatible with home racing wall pack power supplies
ADVICE / RECOMMENDATION:
Before using the motor, it is advisable to lubricate both ends of the axles with a lubricant that penetrates deeply between both parts (bearing/axle).
Our advice is to keep the motor vertical (look the photos) and lubricate by depositing a ONE DROP of oil rotating and moving the axle so that it penetrates well. Let stand approx. 20 minutes in this position and repeat on the opposite side.
Subsequently clean the excess of lubricant and connect the motor to a power suply at approx. 5/6V and roll for five minutes so that the brushes adapt to commutator and. -ALWAYS-, in the desired direction of rotation.
After, and once mounted, lightly lubricate the axles before each race removing excess oil so as not to stain the track and the interior of the car.
Old Part Number SLPL090003
