1 motor support unit including bearings and spring elements
Material PA6GF15 - this is glass fiber reinforced polyamide, almost indestructible
Important - read the text to the end !
included in the delivery are:
Base support, counter bearing,
Stainless steel screws
2 screws for the counter bearing M 2.5 x 6
2 screws M 2.5 x 12
2 screws M 2.5 x 14
2 screws M 2.5 x 16
2 medium hard springs
2 ball bearings ABEC 5
no adjustment or set-up necessary - the counter bearing is centered and screwed precisely using a hexagon socket !
A hardened axle with 65 mm is used as standard for this purpose - with some models a 60 mm axle is sufficient
Installation is very easy to do even for newcomers / laypeople!
The engine mount also serves as a replacement for defective or lost engine mounts.
The MT is compatible with all Carrera D124 (except Exclusiv Porsche Spyder and Audi R10 Spyder and models with a closed magnetic shaft must remove the hexagon. For example Ferrari 575 or Corv. C6R.
The engine mount can be installed with a spring or fixed (without suspension).
It is no longer necessary to set the gear backlash - the total number of teeth must, however, have 60 teeth
Attention - it is no longer possible to assemble the central or rear magnets !!!
Adjustments are required for some vehicles:
M1 - on the counter bearing, the hexagon is slightly slanted here - error in the Carrera shape
Porsche 991 - reworking on the inlet where the recess for the gear is located
